Operation—Operating the Machine Electric Quik-Tatch™ Installing an attachment: 1. Park machine on level surface. TX1067250A —UN—04NOV09 2. Lower boom until boom is resting on boom stops. 3. Disengage park brake. NOTE: The switch will automatically return to center position when released. The mounting plates will stop at the position they are in at the time the switch is released. 4. Press and hold lower half of Quik-Tatch™switch (1) to retract lock pins. Red indicator should be visible in indicator window (2). Electric Quik-Tatch™Switch 5. Tilt mounting plates (3) forward. 6. Drive forward and raise boom. Guide top of mounting plates under attachment mounting brackets.
TX1067235A —UN—05NOV09 7. Raise and rollback mounting plates. Back of attachment should rest against front of mounting plates. 8. Lower boom until boom is resting on boom stops when attachment is fully supported. 9. Roll attachment out. Stop with bottom edge of attachment 50 mm (2 in.) from ground. Electric Quik-Tatch™ 1— Quik-Tatch™Switch 2— Indicator Window (2 used) 3— Tilt Mounting Plate (2 used) 10. Press and hold upper half of Quik-Tatch™switch to engage lock pins. Red indicator should not be visible in indicator window. 11.
Activate lift cylinders to raise attachment and extend bucket cylinders to tilt attachment at a slight downward angle so that the bottom of the Quik-Tatch™is visible. CAUTION: Prevent possible crushing injury from falling attachment. Be sure attachment is on the ground before continuing. CAUTION: Prevent possible crushing injury from falling attachment. Be sure pins are engaged before operating boom and bucket. Red indicator should not be visible in the indicator window. 2. Lower boom until attachment is securely resting on ground. 3. If attachment does not have hydraulic hoses connected to couplers, proceed to step 4.
If attachment is not securely latched, follow the removal procedure, and then repeat installation procedure. If attachment does have hydraulic hoses connected to couplers: Engage park brake and stop engine. Raise interlocking seat bar and unfasten seat belt. Disconnect hydraulic hoses from couplers. Enter machine, fasten seat belt and lower interlocking seat bar. Start engine and disengage park brake. 12. Visually inspect attachment mechanism to verify that pins are fully engaged in slots on back of attachment. 13. Connect hydraulic hoses to couplers, if needed. Removing the attachment: 4. Press and hold lower half of Quik-Tatch™switch to retract lock pins.
Red indicator should be visible in indicator window. 1. Park machine on level surface. 5. Tilt mounting plate forward and back machine away from attachment at the same time. Quik-Tatch is a trademark of Deere & Company OUT4001,0000532 -19-23MAR11-2/2 2-2-24 071713 PN=76