Operation—Operating the Machine Auto Idle Operation Auto Idle—EH Controls Auto idle can be enabled or disabled based on a selection in the engagement and monitor unit (EMU) operator menus. Auto idle automatically commands the engine to idle speed if the engine is left running at a speed greater than slow idle with no activation of travel, hydraulic, or auxiliary hydraulic functions for more than 5 seconds. Auto Idle—Manual Controls Auto idle automatically commands the engine to idle speed if the engine is left running at a speed greater than slow idle for more than 5 seconds, the operator is not in the machine, and auxiliary hydraulics are not enabled. 1. Engine is running. 2.
It has been more than 30 seconds since engine start. 3. Park brake is released. 4. Engine speed control dial or engine speed control pedal is more than 5% above idle. 5. Auxiliary hydraulics are not enabled. 6. Left and right joysticks are in center position. 7. No travel, boom, or bucket functions have been activated. 8. Items 1—7 have been true for longer than 5 seconds. Auto idle will become active if ALL of the following are true: Auto idle will become active if ALL of the following are true: 1. Engine is running. 2. It has been more than 30 seconds since engine start. 3. Operator is out of the seat. 4. Engine speed control dial or engine speed control pedal is more than 5% above idle.
5. Auxiliary hydraulics are not enabled. 6. Items 1—5 have been true for longer than 5 seconds. NOTE: AUTO IDLE will be displayed on the EMU when machine is in auto idle mode. NOTE: AUTO IDLE will be displayed on the EMU when machine is in auto idle mode. To deactivate auto idle, rotate engine speed control dial to slow idle then back to desired engine speed. To deactivate auto idle, do any of the following: Adjusting engine speed control dial by more than 5%. If engine speed control dial is not at maximum, moving engine speed control pedal by more than 5%. Move either left or right joystick out of neutral position. Actuate auxiliary proportional switch. NOTE:
Auto idle is also deactivated if engine is shut off. NOTE: Auto idle is also deactivated if engine is shut off. OUT4001,0000537 -19-12NOV09-1/1 Boom and Bucket Speed Settings—If Equipped Utility Rate Selected (Medium speed) - Provides slower response to the joystick command. All functions attain 100% maximum speed at the end of joystick travel. This setting is the default setting from the factory. Precision Rate Selected (Slowest mode) - Provides slowest response to the joystick command. Speed is limited to no less than 80%.
For EH machines with performance package only, one of three boom and bucket speed rate settings can be selected for increased performance and to suit desired operator preference. Press MENU button on the engagement and monitor unit (EMU). Boom and Bucket Rate will be the first screen to appear. Press SELECT button. Cycle through rates using the NEXT button. Rates will appear in the following order: Production Rate Selected (Normal operating mode) - Provides fast response to the joystick command. All functions attain 100% maximum speed for each function. When desired rate appears on the screen, press SELECT button to set that rate and screen will return to Main Menu.
Press MENU button to return to normal run-time display. OUT4001,0000538 -19-10NOV09-1/1 2-2-27 071713 PN=79