Operation—Operating the Machine Creep Mode Operation—If Equipped NOTE: Creep mode only works with ISO control pattern selected. When creep mode is active, the control pattern cannot be changed and the monitor will not indicate a change. Creep mode must be deactivated before the pattern can change. TX1067111A —UN—31OCT09 Creep mode is only available with EH controls and is included as part of the optional performance package. Creep mode is used to limit the travel speed of the machine when the joystick is at full travel. Creep Mode Switch To activate creep mode, press creep mode switch (1) to ON position and move the joystick to neutral.
For two speed machines, if machine is in high range prior to actuation of the switch, the machine will also shift to low range when the joystick is in neutral. 1— Creep Mode Switch increments of 5% above 10%, and in increments of 1% below 10%. If the MENU or SELECT button is pressed, the display will return to the previous menu display and the operator is allowed to again navigate the display as normal. The operator can return to the speed limit setting screen by either cycling the creep mode switch off and then on again or by navigating the menus and selecting creep mode.
Once the creep mode switch is turned on, the engagement and monitor unit (EMU) will display the speed limit setting screen. The creep mode limit will come up at the last setting. The operator can press the NEXT or BACK button of the EMU to increase or decrease, respectively, the speed limit setting. This number will become immediately active to control the speed. Therefore, the speed limit can be adjusted while the machine is moving. The display will show the percentage of allowed maximum speed in When machine is in creep mode, the creep mode indicator (snail) will illuminate on EMU. OUT4001,0000536 -19-12OCT10-1/1 2-2-26 071713 PN=78