Maintenance—Machine Operating in Cold Temperature Climates IMPORTANT: 326D and 328D manual control machines only: Prevent possible damage to the hydrostatic pump. Do not use synthetic oil (SAE 0W-40) in the hydraulic system on manual control units (non-electrohydraulic). (S.N. 214398—) Machines are shipped from the factory with 0W-40 engine oil in the engine. The following oils are recommended for optimum starting performance:
Engine Oil SAE 0W-40 Hydraulic Oil SAE 0W-40 Hydraulic Oil 326D and 328D with manual controls SAE 10W-30 Machines equipped with the optional cold start package are shipped from the factory with 0W-40 engine oil in the hydraulic reservoir except for 326D and 328D manual controls. All 326D and 328D with manual controls are shipped with 0W-40 in the engine and 10W-30 in the hydraulic reservoir. Machines without the optional cold start package are filled with 10W-30 in the hydraulic reservoir. (S.N. —214397) Machines were shipped from the factory with 10W-30 engine oil in the engine and hydraulic reservoir.
MB60223,000023D -19-21NOV11-1/1 Alternative and Synthetic Lubricants Conditions in certain geographical areas may require lubricant recommendations different from those printed in this manual. Synthetic lubricants may be used if they meet the performance requirements as shown in this manual. Some John Deere brand coolants and lubricants may not be available in your location. The temperature limits and service intervals shown in this manual apply to both conventional and synthetic lubricants. Consult your John Deere dealer to obtain information and recommendations. Re-refined base stock products may be used if the finished lubricant meets the performance requirements.
DX,ALTER -19-11APR11-1/1 Diesel Engine Break-In Oil IMPORTANT: Avoid engine damage. DO NOT use break-in oil in this engine. See Diesel Engine Oil in this section. OUT4001,0000523 -19-29OCT09-1/1 3-1-6 071713 PN=86