. OPERATION EXPLANATION OF COMPONENTS If the ambient temperature is below - 15 ° C (5 ° F), turn on the electricity immediately after stopping the engine on the previous day to maintain the engine temperature. The above table shows the standard values. If the weather conditions at the jobsite are unusual, it is effective to investigate the normal conditions that match the area, and use that as the standard. NOTICE For details of the starting operation when the ambient temperature is below 0 ° C (32 ° F), see "STARTING IN COLD WEATHER (PAGE 3-97)". If the ambient temperature is above 0 ° C (32 ° F), do not pass electricity through the system.
The oil temperature will rise and this will cause deterioration of the oil. If the ambient temperature is below - 20 ° C (- 4 ° F), and the engine has been stopped for more than two hours, use this engine preheating heater to maintain the temperature. 4. When the preheating operation is finished, turn off the power switch, disconnect the cable, and screw a protective cap in the input receptacle on the machine. 5. Start the engine. NOTICE Do not start the engine while the electricity is turned on. Always turn the power switch OFF before starting the engine. If the engine is started with the electricity still turned on, it will cause failure of the coolant heater. 3 - 75 3.
The time to keep the electricity on differs according to the ambient temperature and the type of oil being used. Ambient temperature Type of oil Min. ON time for electricity -30°C (-22°F) SAE 10W Min. 2 hours