. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING repair it. loose bolts, or leakage of oil from 6. Check for damage to handrail and loose bolts Repair any damage and tighten any loose bolts. parts. Clean off any dirt on the 3 - 76 WALK-AROUND CHECK Before starting the engine, walk around the machine a nd look at the underside of chassis for a nything unusual l ike loose bolts and n uts, leakage of fuel, oil and coolant. Also check the condition of the work equipment and the se wiring, play, and collection of dust at places that reach high temperature. the hydraulic system.
Also check for loo se wiring, play, and collection of du st at places that reach high temperature Leakage of oil or fuel, or accumulation of flammable mat erial around high temperature parts, such a s the engine m uffle r or turbocharger, ma Check carefully, a y cause fire. nd if any abnormality is found, repair it or contact your Komatsu distributor. nd if any abnormality is found, repair it or contact your Komatsu distr Do not get on or off the machine from the rear. Using this position is dangerous becaus e it is easy to slip and you c anno t be seen from the op erator's compartment. Always use the h andrail and step at the side wh en getting on or off the machine.
If the machine is a t an angle, reposition it level before Perform the follow ing inspections and cleaning every day before starting engine for the day's 1. Check for dam age, wear, play in work equipment , cylinders, linkage, hoses Check for crac found, repair it ks, excessive wear, play in wotk eq uipment, cylinders, linkage , and hoses. If any abnormalit y is . 2. Remove dirt a nd debris from around the engine, b attery, and radiator Check for dirt grass, etc.) ac parts. If any di accumulated around the engine or r adiator. Also check for flam mable materi al (dry leave s, twigs, cumulated around the battery, eng ine muffler, turbocharger, or other high temperature engine , remove them.
temperature rt or flammable materials are found 3. Check for coo lant and oil leakage around the eng eakage from the engine and coolan t leaks from the cooling sy stem. If any a bnormality i s found, 4. Check for leak age of oil from power train case, fin al drive case, hydraulic tan k, hose, joint s Check that the Check for leak re is no oil leakage. If any abnorma lity is found, repair the pla ce where the oil is leaking age of oil from the undercover. Che ck the ground for traces of oil leakage. 5. Check the un rollers If any damage , wear, or oil leakage is found, repa ir the problem and tighten t 7.
Check for dam age to gauges, lamps on the instru ment panel, and loose bolt Check for da surface. mage to the panel, gauges, and lamps. Replace any damage