. OPERATION OPERATION IN COLD AREAS (Ambient temperature below 10 ° C (50 ° F)) REMARK 5. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. 3 - 102 NOTICE Do not perform operations or suddenly operate the levers when the hydraulic oil is at a low tempe rature. Always perform the warming-up operation until the hydraulic oil range. This will help extend the temperature monitor displays the green machine life. Do not suddenly accelerate the operating temperature. engine before the machine reaches full Do not run the engine at low or high idle for more than 20 minutes.
This will cause oil leaks from the tu rbocharger oil supply piping. If it is necessary to run the en gine at idling, apply a load from time to time or run the engine at a mid -range speed. lamp (3) flashes or the buzzer sounds and check for the cause. If engine oil pressure caution intermittently, stop the engine 1. Turn fuel control dial (1) t o the center position between LOW IDLE (MIN) and HIGH ID medium speed for about 5 LE (MAX) and run the engine at minutes with no load. 2. Blade control lever (2) to t he full RAISE position, then hold the lever in position, and opera tilt relief positions for 5 mi 3. Finally, operate blade con te slowly to the left tilt relief and right nutes.
trol lever (4) and ripper control lever to operate the blade and r If the oil temperature in t raised, there will be a tim equipment and steering. ipper cylinders several times. he work equipment is not properly e lag in the response of the work 4. After warm-up is complete d, check gauges and caution lamps for proper operation. If any Continue to run the engi coolant temperature gaug range (B). (A): White range (B): Green range (C): Red range problem is found, repair it. ne under a light load until engine e indicator (4) is within the green If the power train oil temperatur longer to accelerate to the ma e is not raised sufficiently, it will take ximum speed.