. OPERATION OPERATION allow it to cool down gradually, then stop it. 3 - 103 STOPPING ENGINE NOTICE NOTICE If th e engine is s topped witho ut allowing it to cool down, there is danger that the service l ife of various parts of the engine w ill be reduced. Except in If emergencies, the engine ov never stop th erheats, do n e engine suddenly. ot stop it suddenly. Run it at low speed to 1. Lower the work equipment to the ground. (MIN) positions and 2. Turn fuel c ontrol dial ( 1) in the low idling run the en gine at low idling speed for 5 ol down. minutes to allow the engine to g radually co 3. Turn the k ey in starting switch (2) to the O The engin e will stop.
REMARK When the k ey in starting switch (2) is turned to the OFF position, t i t s c he engine stops, but the machine power supply is not cut y. mmediatel The power supply is m aintained for severa l seconds to enable he controll er to save t he operating condit ion to memory and huts down the system after that. The length of time that the ply is maintained depends on the operating after that. The len power sup ondition. Even when the cooling f an is being operate d in reverse or in the c i t c leaning m ode, the machine power s upply is not cut mmediatel y when the k ey in starting switc h (2) is turned to the OFF positio n. supply is maintained for seven seconds to protect lic circuit.
During that time, the fan operation n lamp on the monitor panel flashes. The power he hydrau lic circuit. onfirmatio n lamp on th e monitor panel flas 4. Remove th e key from