. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION 3 - 141 AFTER RUNNING OUT O F FUEL When starting the engine agai n after running out of fuel, fill with fu el, then b leed the air from the fuel system before starting the engine. d be careful not to run out of fuel. Always watch the fuel level an f the engine has stopped beca use of lack of fuel, it is necessary to use t he p riming pump to b leed the air completely rom the fuel circuit. This engine consists of higher precision parts than on the conventional fuel injection pump and nozz le, so if dirt gets in, it will cause problems.
If there is any dirt stuck to the fuel line, use fuel to wa sh it off c ompletely. Be careful when opening the ai r bleed plug at the fuel filter head and t he ai r bleeder of the supply pump. The system is still under pressure and fuel may s purt out. 1. Fill the fuel tank with fuel. (B) at the fuel filter head (1). 2. Loosen air bleed plug (A), 3. Loosen the knob of priming pump (2), then pump the knob until no more bubbles come ou t of air bleed plug (A). 4. Wrap sealing tape around air bleed plug (A) before tightening it. 5. Operate the priming pum p again and check that no more fuel from air bleed plug (B). 9 Nm (0.5 to 0.7 kgm , 3.6 to 5.1 lbft) he supply pump. pprox.
90 - 100 times until no more bubbles come out with the 6. Tighten air bleed plug (B). Tightening torque: 4.9 to 6. 7. Loosen air bleeder (3) of t 8. Pump priming pump (2) a more bubbles come out with the f air bleeder (3). Tightening torque: 4.9 to 6. uel from air bleeder (3), then tighten 9 Nm (0.5 to 0.7 kgm , 3.6 to 5.1 lbft) x. 50 times) until the priming pump 9. Continue pumping (appro (2) becomes stiff and th becomes continuous. e overflow valve release sound g pump (2) and tighten it. 10. Push in the knob of primin 11. Turn the key in the starting switch to the START position and start the engine.
When doing this, do not cra start, wait for at least 2 mi nk the starting motor continuously f or more t han 20 seconds. If the engine does not nutes, then try again. Perform this operation a maximum of 4 12. If the engine does not star t, repeat the procedure from Step 2