Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING METHOD OF TOWING MACHINE WARNING 3 - 142 Serious injury or death could re sult if a disabled machine is towed incorrectly or if there is a mistake i n the selection or inspection of the wire rope. If the engine does not start, pu t blocks under the track to prevent the machine from moving, then rel ease the brake. If blocks are not use, e may move suddenly. there is danger that the machin Always check that the wire rope used for towing has ample strength for the weight of the machine being towed. Never use a wire rope which ha s cut strands (A), reduced diameter (B), or kinks (C). There is danger tha t the rope may break during the towing operation.

n handling wire rope. . Always wear leather gloves whe Never tow a machine on a slope During the towing operation, ne ver stand between the towing machine and the machine being towed. Operate the machine slowly and be careful not to apply any sudden load to the wire rope. NOTICE this machine is 205,800 N (21,000 kg). The maximum towing capacity for Always carry out towing operation s within the maximum towing capacity. For details of the method of to wing, please contact your Komatsu distributor. If the engine stops or the oil pressure in the brake circuit lowers because of a trouble i n the hydraulic system, the brake works and the machin e cannot move.

To move the machin e in t his ca se, the oil pressure in the brake circuit must be heightened to the s pecified level with a special device. Ask your Komatsu d istributor . ut inspection and Moving a machine by towin g is only used to move it to a place where it is possible to carry o pection and maintenance. It is not intend ed for moving the machine long distances. Do not use this method for towing the this the machine for long distances. If it is impossible to operate the steering and brakes of the machine being towed, do not let a nyon e ride on the machine. Keep the angle of the towing line to the minimum.

Operate the machine so th at the ang le does n ot become greater than 30° from the straight lin e.