Komatsu — REVERSE AND REPLACE THE END BITS AND CUTTING EDGES

. MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE THE END BITS AND CUTTING EDGES WARNING equipment lock lever. 57.9 lbft) 4 - 33 It is dangerous if the work equip ment moves by mistake when the cutting edges and end bits are being reversed or replac Set th with work Reverse or replace the end bi ts and cutting edges before i t is wor n out to the blade en 1. Raise the blade to a prop er height, position a block un der the frame to prevent the blade from falling. 2. Operate the work equipm ent lock lever to the LOCK p osition. If the cutting edge and the end bit on both sides are w orn out, replace with new on If the mounting surface is worn, correct it before turnin 3.

Loosen nut (1) and remo ve bolt (2). Then remove the cutting edge and the end bit and clean the mounting surface. 4. Reverse or replace the cu tting edge and the end bit whe n worn out. If bolt (1) and nut (2) are da maged, replace them with ne w ones at ade, then tighten partially. Drop the 5. blade three to five times o n to the ground or rock to rem ove any play in bolt (2), then tighte n it to the correct tightening torque. When installing end bit (3) , put top surface (4) of the e nd bit in close contact with stoppe r (5), then tighten with the bo Tightening torque: 628 ± 79 Nm (64 ± 8 kgm, 462 ± 57 6. After several hours of run