Komatsu — CLEAN, CHECK RADIATOR FINS AND OIL COOLER FINS

. MAINTENANCE SERVICE PROCEDURE CLEAN, CHECK RADIATOR FINS AND OIL COOLER FINS CLEANING BY ROTATING COOLING FAN IN REVERSE DIRECTION 3. Set fan rotation selector switch (2) to the cleaning position (CLN:(C)). direction. 5. Run the engine at high idle. 4 - 34 Carry ou t this procedure if there is an y mud or dirt stuck to the radiator or REMARK Check th e hydraulic cooler hoses. If a ny hose is cracked or hardened by age, replace with a new hose . Also c heck and tight en all loose hose clamps. NOTICE When rota of flying d ting the cooling fan in the reverse direction, be extremely careful ust.

When sto direction, pping the engine when the coolin first run the engine at low idling, g fan is rotating in the reverse then stop it. The dust and dirt stuck to the radiator and cooler can be blown out by rotatin g the cooling fan in the rever starting switch (1) to the "OF F" position and stop the engine starting switch (1) to the "ON REMARK If the eng ine is running, the direction of rotation of the fan will not change e ven when the fan rotation se lector switch is operated. Fan oper that the d ation confirmation lamp (3) wi irection of rotation of the fan ll flash to inform the operator has not been switched. Stop the engine, then start it again.

Th e direction of rotation of the fan will b e switched. starting switch (1) to the ST ART position and start th e engine. T he cooling fan will rotate in ct the time for running the en gine at high idle as follow s according to the conditio n of cloggin al clogging: 1 to 2 minutes ssive clogging: 2 to 3 minute completing the cleaning, run the engine at low idle for approx. 10 starting switch (1) to the "OF F" position and stop the engine