Komatsu — CHECK AND ADJUST AIR CONDITIONER

. MAINTENANCE SERVICE PROCEDURE CHECK LEVEL OF REFRIGERANT(GAS) WARNING REMARK 4 - 39 REPLACE BELT 1. Loosen 4 bolts (1) and jac to the side. 2. Replace the V-belt. When adjusting the V directly with the bar. U 3. Tighten jack bolt (2) and V-belt. The standard def (0.4 in) when pressed wit kg) at a point midway bet pulley and fan pulley. k bolt (2), then move compressor (3) -belt, do not push the compressor se jack bolt (2). bolts (1), and apply tension to the lection for the belt is approx. 10 mm h a finger force of approx.

58.8N (6 ween the air conditioner compressor If the refrigerant used in the air c onditioner gets into your eyes or on your hands, it may cause loss of sight or frostbite. Do not touch the refrigerant. Never loosen any part of the refri gerant circuit. any point where the refrigerant gas is Do not bring any flame close to leaking. If the level of the refrigerant ( gas) is low, the cooling effect will be reduced. Run the engine at h igh idling, and check the flow of the circuit through the sight glass of the s running at high speed. ow: Suitable y):

Lack of refrigerant refrigerant in the refrigerant receiver (1) when the cooler i No bubbles in refrigerant fl Some bubbles in flow (bubbles pass continuousl When there are bubbles, the refrigerant gas level is low, so contact your refrigerant de air conditioner is run with cause damage to the com aler to have refrigerant added. If the the refrigerant gas level low, it will pressor. refrigerant. New R134a is used as the OPERATING AIR CONDITIONER OFF-SEASON Even during the off-season, o perate the air conditioner for 3 to 5 minutes once a month to m aintain the oil film at al parts of the compressor.