. MAINTENANCE SERVICE PROCEDURE REPLACE PRE-FUEL FILTER CARTRIDGE WARNING Prepare a filter wrench and a container to catch the fuel. 1. Close the fuel valve (1). 2. Set the container to catch the fuel under the pre-fuel filter cartridge. 3. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. 4. After removing the cartridge, turn cup (3) of the water separator installed to the bottom of the cartridge counterclockwise. (This cup is used again. If it is damaged, replace it with a new part.) When the seal ring has been replaced, coat the surface with clean fuel before installing it.
4 - 53 After the engine has been ope rated, all parts are at high temperature, so do not replace the filter imme diately. Wait for all parts to cool down before starting t he operation. side the engine fuel piping system when the engine is running. High pressure is generated in When replacing the filter, wai t for at least 30 seconds after stopping the engine to let the internal p ressure go down before replacing the filter. close. air bleed plug in the fuel filter head. It is still under pressure, so fuel may spurt out. Do not bring any fire or flame Be careful when opening the air bleed plug in the fuel filter head.
It is still under pressure, so fuel m NOTICE Genuine Komatsu fuel filter c artridges use a special filter that has highly efficient filtering ability. When replacing the filter cartridge, always use a genui ne Komatsu part. The common rail fuel injectio n system used on this machine consists of more precise parts than th e conventional injection pump and nozzle. If any part other than a genuin e Komatsu filter cartridge is used, dust or dirt may get in and cause pro blems with the injection system. Always avoid using substitute parts. When carrying out inspection or maintenance of the fuel system, pay more attention than normal to t he entry of dirt.
If dirt is stuck to any part, use fuel to wash it off completely. 5. Install cup (3) to the botto m of the new pre-fuel filter cartridge. When doing this, always rep lace the seal ring with a new part. Cup tightening torque: 10 Nm (1.0 kgm , 7.2 lbft)