. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 54 6. Check that the drain plug( 4) at the bottom of th e pre-fuel filte cup(3) is tightened secure Tighte ning torque: 0.2 to 0 0.3 lbft 7. Clean When filling cap (A) fitte the filter cartridge with fuel, carry out the filling operation with d. Cap (A) acts 8. Fill the (B) in t filter cartridge with he new filter cartrid clean fuel through the 8 small holes ge. of the filter cartridge with oil. 9. Coat t he packing surface of the filter cartridge w 10. Remo ve filter cartridge ca p (A) and install to the filter holder. 11.
When installing, tighten un til the packing surfac e contacts the seal surface of the filter holde r, then tighten it 3/4 of a tu rn. If the fi lter cartridge is tight ened too far, the pac king will be da maged and this will lead to le akage of fuel. If the filter c artridge is too loose, fuel will also leak fro m the packing , so always tighten the correc t amount. r. Wh en tightening with a filter wrench, be extre mely careful not to dent or damage the filte 12. When carrying out standar d replacement of the f uel filter cartri dge (every 1000 hours), replac e the cartridge and bleed t he air. For details, see "REPLACE FUE L MAIN FILTE R CARTRIDGE (PAGE 4-60 13. Open t he fuel valve (1).
14. Start th e engine, check tha t there is no leakage of fuel from the filter seal surface or water separator mounting surface, then run for approx. 10 minutes at low idling. filter s eal surface or wate