Komatsu — CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL

. MAINTENANCE SERVICE PROCEDURE REPLACE POWER TRAIN OIL FILTER ELEMENT WARNING 2. Remove bolts (1) and cover (2) is lifted up, then take out element (3). CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING mud get in when adding oil. 4 - 55 Immediately after the engi ne is stopped, the oil and pa rts are at high temperature, and may cause bu rns. To prevent this, wai for the temperature to go down before starting the op eration . Before opening the filter c ases, depress the brake pe dal several times to release the pressure, the n lock the brake pedal. I there is still pressure insid e the filter, oil may spurt ou t. 1. Open the engine side cover on the left of the m achin 3.

Clean inside of the ca se and the removed part s, then instal l a new element. Replace the O-ring wi There is danger that oil may s purt out under internal pressure, s o stand to t he side, and gradually turn t he plug to release interna pressure before removing th 1. Place the machine on a horizontal place. (G) and check whether the final drive lower edge of the plug hole. dd oil through oil level plug (G). 2. Remove oil level plug (G) and check whethe case is filled with oil to lower edge of the plug 3. If the oil level is low, a dd oil through oil level pl ug (G) Before removing the o il level plug (G), remove all the mu d and dirt from around the p irt or