. MAINTENANCE SERVICE PROCEDURE pressure of has contact your Komatsu METHOD OF RELEASING PRESSURE IN HYDRAULIC CIRCUIT NOTICE 4 - 68 In distributor. Work eq uipment d oes not g Stops w hile going he accumulato gone down. P Finish the ste ps of operating the b lade control lever to the front and back, and to the right and l eft, to each stroke end with in 15 seconds afte r the engin e has stopp ed. After the engine stops, pressure inside the accumulator begins to gradually go dow n, so the pressure cannot be released e xcept right af ter the engine stops. 1. Lower t he work e quipment and stop th e engine. 2. Turn the starting switch to the ON pos 3.
Set the work equipment loc k lever to t he FREE 4. Operate the blad e control l ever fully to the front, rear, left, and right to release th e pressur e from the hydraulic circuit When r eleasing t he pressu re from the hydraulic r circuit, operate the rippe r control l ever fully to the left and r igh t (i n the case of the fixed multi-sha nk ripper) o r to th e fr on t, r ear, and righ t (in the c ase of the variable m ulti-shank 5. Set the work equipment loc k lever to t he LOCK