Komatsu — CHECKING CHARGE PRESSURE OF NITROGEN GAS IN ACCUMULATOR (FOR CONTROL CIRCUIT)

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 7. Operate the blade control lever fully in the direction to lower the blade. NOTICE 4 - 67 3. Raise the work e quipment (blade) to t he maximu m height. NOTICE he following procedure for lowering the blade to the ground within 15 seconds after stopping the engine. Carry out t he following procedure f or lowering the blade to t he ground with in 15 seconds af When the e ngine is stopped, the pr essure inside the accumulator gradually goes d own, so thi s inspection can be c arried o ut only immediatel y after the e ngine is sto pped. 4.

Leave the work e quipment raised to th e maximum height, t the st arting switc h to the O FF position and stop th e engine 5. Turn t he starting switch to t he ON pos 6. Set th e work equipment loc k lever to t he FREE p osition Check tha blade con trol lever to the LOW ER position 8. Chec k that the w ork equipm ent goes d own to the g round its ow n weight. 9. This c ompletes t he inspect If the nitrog en gas char ge pressure in the accu mulator is low and operation s are continued, it will become impossible to release the remaini ng pressure inside the hydraulic cir cuit if a failur e occurs o n the