Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING cause burns. Wait for the NOTICE of gauge (G). 4. If the oil level is below the window of sight gauge (G), remove bolts (1) (6 pieces) and take cover (2) off. Then, add the oil through oil filler (F). 5. If the oil is above the window of the gauge, drain the excess oil from drain plug (P), then check the oil level again. REMARK Use the supplied hose to prevent oil from spraying out into the surrounding area. 6. If the oil level is appropriate, tighten the cap of oil filler (F) securely and remove the hose.

4 - 53 The parts and oil are at high temperature immediately after the engine is stopped, and may starting the work. , turn it slowly to release the internal pressure, then remove it. temperature to go down before When removing the oil filler cap If oil has been added to above the window in the gauge, stop the engine, wait for the hydraulic oil to cool, then drain the excess oi l from the drain plug. If the oil le vel is too high, it will damage the hydraulic circuit and cause the o 1. Set the machine in position as follows to check the oil level. front tires to the upright position and face the wheels straight to the front.

Return the leaning of the Set the front frame and r Return the blade sideshi it lightly to the ground. To drain the oil from th accumulator switch ON switch OFF and lower th front tires to the upright position and face the wheels strai ear frame facing straight (articulated angle = 0 deg.). Insta ll the articulate lock pin. ft to the center of the machine, set the blade at right angles to the chassis and lower e accumulator on machines equipped with a blade accumulator, turn the blade 2. Start the engine and run at 3. Check with sight gauge (G).