John Deere 6059T — John Deere 6059T User Manual

ARMY TM 9-2815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 FIGURE 3-40. Installing Cover On Yoke k. Position yoke assembly (39) on magnetic switch assembly (24) engaging tab on yoke assembly with notch in magnetic switch, refer to FIGURE 3-41. Secure with two through bolts (7, FIGURE 3-15), new lockwashers (8), washers (9), and new preformed packings (10). Tighten through bolts 5.1 to 8.7 ft-lbs (6.9 to 11.8 Nm). FIGURE 3-41. Installing Yoke I. Connect yoke assembly lead wire (6) to terminal on magnetic switch assembly. Tighten nut to 18.1 to 26.0 ft-lbs (24.5 to 35.3 Nm). Ensure rubber boot (37) is installed securely. 3-12.7. Installation.

NOTE To aid in installing starter and spacer, place a 3/8 inch x 3 inches (9.52 mm x 7.62 cm) guide stud in one of the starter mounting holes in flywheel housing. a. Remove cover in flywheel housing. b. Place spacer (4, FIGURE 3-15) and starter on flywheel housing and secure with two screws (1), new lockwashers (2), and washers (3). Tighten screws 30 to 35 ft-lbs (41 to 47 Nm). c. Connect electrical leads to starter as tagged during removal. d. Install coolant overflow bottle and mounting plate, refer to end item maintenance manual. Change 3 3-50