John Deere 6059T — John Deere 6059T User Manual

ARMY TM 92815-256-24 AIR FORCE TO 38G1-96-2 MARINE CORPS TM 2815-24/5 Section VI. INTAKE AND EXHAUST SYSTEM MAINTENANCE 3-13. TURBOCHARGER. 3-13.1. Removal. Warning After operating engine, allow exhaust system to cool before removal. Failure to observe this warning could result in personal injury. CAUTION When cleaning turbocharger, do not spray directly into compressor cover or turbine housing. If turbocharger inspection is required, do not clean exterior prior to removal. Doing so may wash away evidence of a potential failure mode. a. Thoroughly clean exterior of turbocharger and surrounding area to prevent entry of dirt into air intake system during removal. b.

Remove air intake line and exhaust line from turbocharger (12, FIGURE 3-42), refer to end item maintenance manual. c. Loosen clamps securing air intake manifold hose to turbocharger, refer to paragraph 3-15 and FIGURE 3-45. d. Remove capscrew (1), lockwasher (2), and clamp (3). e. Disconnect oil inlet line (4) from fitting (5) on top of turbocharger (12). NOTE If it is necessary to remove oil lines, drain lubrication system, refer to end item maintenance manual. 3-51