Komatsu — Kickdown Switch

OPERATION Kickdown Switch Use the kickdown switch (14) to shift down the transmission. When the gearshift lever is at F2 and the switch at the head of the lift arm control lever is pressed, the transmission shifts down one range. Use this function when you need to increase the drawbar pull in digging operations. When the transmission shift range is in FORWARD 1st (F1) and the power mode selector switch is at E mode and switch (14) is pressed, it is possible to switch to P mode. Use this function during scraping-up operations or during digging operations when it is necessary to increase the lifting force. When using E mode: 2nd E mode 1st E mode 1st P mode When using P mode:

2nd P mode 1st P mode If the transmission is in auto-shift and the travel speed is below 10.5 km/h (6.5 mph) in any speed range when traveling in either forward or in reverse, the kickdown switch is actuated; it is now possible to shift down to 1st. Even if the travel speed is more than 10.5 km/h (6.5 mph), this switch can be used to shift the transmission down. Each time the kickdown switch is pressed, the speed range shifts down one range at a time (F4 F3 F2). Remark When canceling the kickdown, operate the directional lever. In manual shift, the kickdown can be canceled by operating the gearshift lever to any position other than 2nd.

It is also possible to cancel the kickdown by turning the starting switch OFF. In auto-shift, if the travel speed increases after the kickdown, the auto-shift shifts the gear up by the auto-shift. In auto-shift, when traveling at more than 18 km/h (11.2 mph) in 3rd or at more than 28 km/h (17.4 mph) in 4th and the kickdown switch is pressed, the transmission does not shift down. This prevents the engine from overrunning. 2-50 WA430-6