OPERATION When the switch is released, it automatically returns to its original position. The maximum time for continuous operation of the emergency steering is 60 seconds. When using the emergency steering, travel at a speed of less than 5 km/h (3.1 mph). For details, see “Emergency Steering (if equipped)” on page 2-116. Cooling Fan Auto-Reverse Rotation Switch Use the cooling fan 3-position, rocker switch (23) to rotate the hydraulic-controlled cooling fan in the reverse direction when cleaning the radiator. Since this is a spring-loaded switch, when it is set to ON, the switch will return to the neutral position (c) when the switch is released.
It is not necessary for the operator to hold the switch in the ON position. Run the engine at idling when operating the switch. Position (a): Auto-reverse rotation function ON The fan automatically rotates in reverse for two minutes every two hours. The pilot lamp inside the switch and the cooling fan reverse rotation pilot lamp on the machine monitor light up. Position (b): Manual reverse rotation switch ON When the fan is rotating in the normal direction and the switch is pressed once, the fan will rotate in reverse; if the switch is pressed again, the fan will rotate in the normal direction.
When the fan is rotating in the reverse direction, the cooling fan reverse rotation pilot lamp on the machine monitor lights up. Reverse rotation continues for approximately ten minutes after the switch is pressed. Position (c): Normal (OFF) The cooling fan is constantly set to normal rotation. For details about cleaning the radiator, see “Clean Radiator Fins and Cooler Fins” on page 3-42. It is possible to adjust the following the automatic reverse rotation functions: Cycle fan automatic reverse rotation (Standard: two hours) Continuous time fan automatic reverse rotation (Standard:
two minutes) Ask your Komatsu distributor to carry out the adjustment Remark When the fan rotation direction is switched, the reverse rotation pilot lamp flashes. To protect the machine, the fan rotation direction cannot change when the fan is operating under high load or in low temperatures. For details, see “Conditions for Switching Fan Rotation” on page 2-55. When the engine is stopped, the fan rotation direction returns to the normal direction. If the switch is set to position (b) (manual reverse rotation ON), the switch returns to position (c) (Neutral) when the switch is released.
Even if position (b) of the switch is not kept pressed, the fan will rotate in the reverse direction for a fixed time. It is not necessary to keep the switch pressed at position (b). During reverse rotation of the fan, if the engine cooling water, hydraulic oil, or torque converter oil overheat (the caution lamp for the oil temperature gauge on the machine monitor lights up), the reverse rotation of the fan is forcibly stopped and the fan switches to rotation in the normal direction. 2-54 WA430-6