OPERATION (1) Side wall (2) Shoulder (3) Tread (4) Breaker or belt (cord layer) (5) Bead (6) Inner liner (7) Carcass 9. Inspect rims. Check the rims (wheels) and rings to confirm that there is no deformation, corrosion, or cracks. In particular, check the side rings, lock rings, and rim flanges thoroughly. Maintenance, disassembly, assembly and repair of the tires and rims requires special equipment and technology, so always contact your Komatsu distributor to perform these operations. 10. Check for loose battery terminals. Tighten any loose terminal. Tightening torque: Portion A: . . . . . . . . . . . . . . . . . . . . . . 5.9 – 9.8 N•m (52 – 87 lbf in) Portion B: . . . . . . . . . . . . .
. . . . . . . . 11.8 – 19.6 N•m (9 – 15 lbf ft) 11. Check for loose air cleaner mounting bolts. Check for loose bolts. Tighten any loose bolts. 12. Clean the cab window. To ensure good visibility through the cab window during operations, always keep the glass clean. It is extremely dangerous to cross from the side of the cab to the step on the front fender. Always articulate the machine fully to the side, then cross on that side from the side of the cab to the step. When crossing, grip the handrail on top of the cab and pay careful attention to the safety of your footing on the platform on the left or right to move to the step on the front fender.
When cleaning the cab glass, use the handrail and step, and always be sure to maintain three-point contact (two feet and one hand, or one foot and two hands) with the handrail and step to ensure that your body is supported properly. Clean the cab glass only on the side to which the machine is articulated. When cleaning the glass on the other side, articulate the machine in the opposite direction before starting. See “Precautions When Cleaning Cab Glass” on page 1-23. 2-78 WA430-6