13. Check rear view mirror, underview mirror. OPERATION Check that the mirrors are not damaged. Replace them if they are damaged. Clean the surface of the mirrors and adjust the angle so that the operator can see the area to the rear and under the machine from the operator's seat. When cleaning the mirrors, use a mop with a long handle. 14. Check for loose ROPS mounting bolts. If there are loose bolts, contact your Komatsu distributor to obtain the tightening torque. If any bolts are damaged, contact your Komatsu distributor to obtain genuine Komatsu bolts. Check for damage and loose bolts on the handrail and steps. Repair any damage and tighten any loose bolts. 15.
Check for damage to gauges, lamps on the instrument panel, and loose bolts. Check for damage to the panel, gauges, and lamps. If there is a problem, replace the parts. Clean off any dirt on the surface. Tighten any loose bolts. 16. Check for damage to the seat belt and mounting clamps. See “Seat Belt Inspection” on page 1-11. Check that there are no loose bolts on the equipment mounting the seat belt to the machine. Tighten the bolts if necessary. Tightening torque:. . . . . . . . . . . . . . . 24.5 ±4.9 N•m (217 ±43 lbf in) If the belt is damaged or fluff is starting to form, or if there is any damage or deformation of the seat belt holders, replace the seat belt.
The seat belt should be replaced at the first sign of wear or damage. It should also be replaced every three years after the start of usage, or five years after the date of manufacture even if there appears to be no abnormality. Remark The date of manufacture of the seat belt is marked on the belt at the place indicated by the arrow in the figure to the right. WA430-6 2-79