Komatsu — Check Water Separator, Drain Water

Check Water Separator, Drain Water OPERATION Each part of the engine is very hot immediately after the engine is stopped. Do not attempt to drain cooling water or remove the filter element cup. High pressure is generated inside the engine fuel piping while the engine is running. Wait for more than 30 seconds after the engine stops for the engine to cool down sufficiently. Then start by draining the cooling water or removing the filter element cup. Do not bring fire close. Check water separator, drain water and sediment. 1. Open the engine side cover on the right side of the machine. The water separator (1) forms one unit with the fuel prefilter and is at the bottom. 2.

It is possible to judge the condition of water and sediment through transparent cap (3). If water or sediment is accumulated, set a container under drain hose (4) to collect the discharged water. 3. Loosen plug (2) and drain the water. 4. Tighten plug (2) as soon as fuel starts to be discharged from drain hose (4). If plug (2) is stiff, coat O-ring (5) of plug (2) with grease. Tightening torque:...............................0.2 – 0.45 N•m (2 – 4 lbf in) 5. Because the sensor can detect if water is accumulated at the bottom of the fuel prefilter, the water separator caution lamp on the machine monitor lights up. Do Steps 2 - 4 to drain the water.

If transparent cap (3) is dirty and the contents cannot be easily seen, clean transparent cap (3) when replacing the filter. When washing, if plug (2) is removed, coat the O-ring with grease, then tighten by hand until it contacts the bottom. A. Set a fuel container under drain hose (4). B. Loosen plug (2), then drain all the sediment together with the fuel from drain hose (4). C. Check that nothing comes out from drain hose (4), then remove plug (2). D. Coat O-ring portion (5) with a suitable amount of grease. When doing this, be careful not to let the grease get on the drain valve water drain port (a) or the plug thread. E. Screw in plug (2) by hand until it contacts the bottom. F.

Remove the fuel container. WA430-6 2-83