OPERATION Check Oil Level in Engine Oil Pan, Add Oil The parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the temperature to go down before starting the operation. Make sure that the machine is in a horizontal position before you check the oil level. 1. Stop the engine and wait at least 15 minutes for the temperature of all parts to go down. Remark After the engine has been operated, wait for at least 15 minutes after stopping the engine before checking the oil level. 2. Open the inspection cover of the right side at the rear of the machine. 3. Take out the dipstick (G) and use a cloth to wipe off the oil. 4.
Fully insert dipstick (G) into filler pipe (F) and then remove it. 5. The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark, add oil through oil filler port (F). If the oil is above the H mark, drain the excess engine oil from drain plug (P) and check the oil level again. If the oil level is correct, tighten oil filler cap (F) securely and close the inspection window. Drain Water, Sediment from Fuel Tank Only poor fuel arrangement specification Loosen valve (1) on the right side of the tank so that the sediment and water is drained together with the fuel. 2-82 WA430-6