OPERATION Check Electric Wiring If fuses frequently blow or if there are traces of short circuits on the electrical wiring, locate the cause and repair immediately, or contact your Komatsu distributor for repairs. Keep the top surface of the battery clean and check the breather hole in the battery cap. If it is clogged with dirt or dust, wash the battery cap to clear the breather hole. Check that the fuses are not damaged, that the fuses are of the correct capacity, and that there are no signs of short circuits or disconnections in the electric wiring. Check that there are no loose terminals or connectors. Tighten any loose parts.
Check the wiring of the battery, starting motor, and alternator carefully. Be sure to check that there is no flammable material accumulated around the battery. Remove all flammable material. Consult your Komatsu distributor about repairs and causes of problems. Check Inflation Pressure of Tires Measure the inflation pressure with a tire pressure gauge while the tires are cool, before starting work. The appropriate inflation pressure differs dependent on the type of work. See “HANDLING TIRES” on page 2-154. Check for damage or wear to the tires and the rims. Check for loose wheel hub nuts (bolts).
Maintenance, disassembly, assembly and repair of the tires and rims requires special equipment and technology, so always contact your Komatsu distributor to perform these operations. Check Condition of Window Washer Spray Operate the window washer and check that the washer fluid is sprayed out properly. If the fluid does not spray out properly, clean the washer nozzle with a safety pin or thin wire. If the condition is still not improved, ask your Komatsu distributor to carry out inspection and repair. Check Wiping Efficiency of Wiper Operate the wiper and check that it wipes the window properly under each operating speed (intermittent, low speed, high).
Operate the window washer to make the glass wet when checking. If the condition is still not improved, ask your Komatsu distributor to carry out inspection and repair. If the wiping condition is poor, it is necessary to clean the surface of the glass or replace the rubber wiper blade. Check Horn Press the horn button and check that the horn sounds. If there is any abnormality, ask your Komatsu distributor to carry out inspection and repair. Check Defroster Function Operate the air conditioner and check that the air blows out properly onto the front glass. If there is any abnormality, ask your Komatsu distributor to carry out inspection and repair.
Operate the rear heated wire glass switch and check that the rear glass surface is heated properly. If there is any abnormality, ask your Komatsu distributor to carry out inspection and repair. 2-88 WA430-6