Komatsu — Adjusting Seat

OPERATION Adjustments Adjusting Seat Park the machine in a safe place and stop the engine when adjusting the operator’s seat. When adjusting the position of the operator’s seat, always set the work equipment lock lever to the LOCK position to prevent accidental contact with the control levers. Always adjust the operator’s seat before starting each operation or when the operator changes shift. When adjusting the seat, put your back against the backrest and adjust to a position where the brake pedal can be fully depressed. Remark When pulling up levers (2) and (3), be careful not to pull up the switch box at the front by mistake. There is danger that the switch box may be damaged.

When the left armrest is at the raised position, do not push down on the tip of the armrest with your hand to support your weight. There is danger that the armrest mount may be damaged. Adjustments (E), (J), and (K) use the air compressor built into the seat. Turn the engine starting switch to the ON position when carrying out the adjustment. (A) Fore-and-aft adjustment Pull lever (1) up; set the seat to the desired position; then release the lever. Adjustment range: . . . . . . . . . . . . . . . . . . . . . . . . . 180 mm (7.1 in) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(10 mm (0.4 in) x 18 stages) (B) Adjusting seat angle Move lever (2) up and, while sitting, push down on the rear of the seat to tilt it backward. Move lever (3) up and push down on the front of the seat to tilt it forward. Adjustment range: . . . . . . . . . . . . . . . . . . . . 24° (front and rear tilt) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (three stages each) (C) Adjusting height of seat Move levers (2) and (3) up and move the seat up or down to the desired position. These levers are also used to adjust the seat angle. Adjust the seat angle to set the seat to the desired height. Adjustment range: . . . . . . . . . . . . . . . . . . . . . . . . . .

65 mm (2.6 in) (D) Adjusting fore-and-aft position of seat cushion Push in lever (4); set the seat cushion to the desired position; then release the lever. Adjustment range: . . . . . . . . . . . . . . . . . . . . . . . . . . 60 mm (2.4 in) 2-90 WA430-6