OPERATION Starting Engine Normal Starting Sit down in the operator’s seat before starting the engine. Do not attempt to start the engine by jumping across the engine-starting circuit. Such an act may cause serious bodily injury or fire. Check that there are no persons or obstacles in the surrounding area and then sound the horn and start the engine. Exhaust gas is toxic. When starting the engine in confined spaces, be particularly careful to ensure good ventilation. Remark Do not accelerate the engine suddenly before completing the warming-up operation. Do not keep the starting motor rotating continuously for more than 20 seconds.
If the engine does not start, wait for at least two minutes before trying to start the engine again. This machine is equipped with an engine automatic preheating device that starts the engine preheating automatically. If the ambient temperature is low, the preheating monitor will light up when the key in starting switch (1) is turned to the ON position to indicate that preheating has been started automatically. 1. Turn the key in starting switch (1) to the ON position (B). If the ambient temperature is low, the preheating pilot lamp (2) lights up and automatic preheating is carried out. Keep the key in starting switch (1) at the ON position until the preheating pilot lamp (2) goes out.
The time that the preheating pilot lamp (2) stays lit varies dependent on the ambient temperature. Lighting times are shown in the following table. 2-98 WA430-6 Ambient Temperature Lighting Time -2°C to -28°C (28.4°F to -18.4°F) 5 seconds to 45 seconds -28°C or less (-18.4°F or less) 45 seconds