OPERATION Work Possible Using Wheel Loader Before you start operations, read the information in this section about the type of work you want to do. The information in this section will help you use the machine correctly. If you intend to do loading operations, read the information in “Loading Operations” on page 2-124. Make sure that you read the “Precautions During Work Operations” on page 2-132 so that you can operate the machine safely. In addition to the operations described in this section, it is possible to further increase the range of applications by using various attachments. Digging Operations Never dig or scoop with the machine articulated.
There is danger that the machine may tip over. Always set the machine facing directly to the front. Never raise the boom with the bucket fully loaded when the machine is articulated. There is danger that the machine may tip over. When the machine is traveling or the work equipment is raised, the moment that the ECSS switch is turned ON, the work equipment will move. If operations are carried out with the ECSS switch left at the ON position, the moment that the ECSS switch is turned ON, the work equipment will move. Remark If the tires slip, the tire life will be reduced. Do not allow the tires to slip during operation.
Loading Piled Soil or Blasted Rock When loading piled soil or blasted rock, drive the machine forward to load. To prevent cutting of the tires caused by the tires slipping, be careful of the following points during the operation. Always keep the operating job site flat. Remove any fallen rocks. When working with stockpiles, operate the machine in 1st or 2nd gear. When loading blasted rock operate the machine in 1st gear. 1. When driving the machine forward and lowering the bucket, stop the bucket at height (A), about 30 cm (12 in) from the ground, and then lower it slowly. Remark If the bucket hits the ground, the front tires will come off the ground and the tires will slip. 2.
Shift down immediately in front of the material to be loaded. When completing the shift down, depress the accelerator pedal at the same time and thrust the bucket into the material. Remark To reduce fuel consumption, depress the accelerator pedal the minimum possible amount. If it is depressed fully, the fuel consumption will increase but there will be no increase in the amount loaded. 2-120 WA430-6