Komatsu — Digging and Loading on Level Ground

OPERATION 6. If there is too much material loaded in the bucket, dump and tilt the bucket quickly to remove the excessive load. This prevents spillage of the load during hauling. Digging and Loading on Level Ground When digging and loading on level ground, set the bucket edge facing down slightly and drive the machine forward. Be careful not to load the bucket on one side and cause an unbalanced load. This operation should be carried out in 1st gear. Do not set the bucket facing down more than 8°. 1. Set the edge of the bucket facing slightly down. If the bucket hits rocks in the ground first, a large shock is generated; this may damage the machine. 2.

Drive the machine slowly forward; push the lift arm control lever slightly to the front; and dig in to scoop up the load, a little at a time. 3. Operate the lift arm control lever slightly up and down to reduce the resistance when driving the machine forward. When digging with the bucket, avoid putting the digging force on one side of the bucket. 2-122 WA430-6