OPERATION Loading Operations Always keep the job site flat. Do not operate the steering wheel suddenly or apply the brakes suddenly while the lift arm is raised with a loaded bucket. This is dangerous. While loading, never thrust the bucket in soil or crushed rock when traveling at high speed. This is dangerous. When the machine is traveling or the work equipment is raised, the work equipment will move the moment that the ECSS switch is turned ON. If operations are carried out with the ECSS switch left at the ON position, the work equipment will move the moment that the ECSS is actuated. Operate carefully.
Select the method of operation which will give the minimum amount of turning and travel in order to provide the most efficient method for the job site. Remark If the tires slip, the tire life will be reduced. Do not allow the tires to slip during operation. Avoid excessive bucket shaking. Cross-Drive Loading This method requires the least time for loading and is extremely effective in reducing the cycle time. Always set the wheel loader facing at a right angle to the stockpile. After digging in and scooping up the load, drive the machine straight back in reverse and then bring the dump truck in between the stock pile and the wheel loader.
V-Shape Loading Position the dump truck so that the direction of approach of the wheel loader is approximately 60° from the direction of approach to the stockpile. After loading the bucket, drive the wheel loader in reverse; turn it to face the dump truck; and travel forward to load the dump truck. The smaller the turning angle of the wheel loader, the more efficient the operation becomes. When loading a full bucket and raising it to the maximum height, first shake the bucket to stabilize the load before raising the bucket. Precautions for Piling Up Loads This prevents the load from spilling to the rear.
When forming a pile, do not drive up the pile high enough to cause the rear counterweight to drag on the ground. Do not set the bucket to the DUMP position when piling up loads. Keep bucket perpendicular to ground when pushing material into a pile. Remark When using the transmission cutoff function, lower the cutoff position so that the cutoff function is actuated when the brake pedal is pressed hard, while ensuring ample braking force. 2-124 WA430-6