Preparations for Loading, Gathering Rocks OPERATION Always keep the job area level and remove any rocks or boulders. When gathering rocks, if the operation is carried out over an area longer than the length of the machine, there is danger that the machine will ride up on boulders and incur cuts to the tires. When gathering rocks, always carry out the operation in an area shorter than the length of the machine. When carrying out operations with the bucket in contact with the ground, do not articulate the machine. Articulation will cause tire slippage and damage to the machine. 1.
Put the bucket horizontally in contact with the ground; drive forward; and gather the rocks that have been scattered after loading and after splitting or blasting. 2. After collecting the rocks in an area the length of the machine, change the direction of the machine to gather rocks and increase the area of level ground. Approaching Facing When approaching the facing and lowering the bucket to the ground, do not drop the bucket suddenly into contact with the ground. If the bucket is dropped suddenly, the bucket, work equipment, area around the pins, and the machine frame will be subjected to excessive shock. This will lead to damage or deformation of various parts of the machine.
In addition, the front wheels will come off the ground and cause the machine to slip. When lowering the bucket to the ground, reduce the lowering speed of the bucket when it is close to the ground and bring it slowly into contact with the ground. Do not set the cutting edge of the bucket at a large angle to the ground surface when digging or lowering the roadbed. Keep the angle between the bucket and the ground surface to a maximum of 8°. If the angle between the cutting edge of the bucket and the ground surface is more than 8° when digging or lowering the roadbed, there is danger of damage to the work equipment.
Do not load the bucket or scoop up the load with the load on the corner of the bucket or on one side of the bucket. This will cause the machine to twist and will reduce the service life of the work equipment and the frame. 1. Set the machine to the travel posture. 2. Set the shift position to F2; gradually depress the accelerator pedal; and raise the travel speed. 3. When lowering the bucket to the ground, reduce the lowering speed of the bucket when it is close to the ground and bring it slowly into contact with the ground. 4. Make angle (a) between the bucket and the ground surface a maximum of 8°. Operate the tilt and dump so that only the cutting edge comes in contact with the ground.
WA430-6 2-125