OPERATION Traveling in Reverse After Excavation Do not operate the steering immediately after starting to travel in reverse. The bucket is still thrust into the rock. If the steering is operated, excessive force will be placed on the bucket or frame. There is danger of damage to the frame. After shifting the transmission, operate the accelerator pedal slowly. If the accelerator pedal is operated suddenly, the tires will slip and cause wear or cutting of the tires. 1. After completing the excavation, shift to R2 and travel in reverse without operating the steering. 2. As a guideline, reverse travel distance (a) should be 1.2 to 1.5 times the length of the machine.
At this distance, the rolling of the tires can prevent wear to the tires. In addition, keep an angle (b) of 60° at the intersection between the straight line from the dilution and the straight line from the dump truck. Remark Decide the steering procedure to match the stopping point of the dump truck and the condition of the dilution. When doing this, decide the stopping point for the dump truck so that the operating angle for the steering is less than 20°. 3. When driving in reverse, do not raise the bucket more than necessary.
Consider the position of the dump truck, the condition of the road surface, the travel speed, and the speed of the work equipment when deciding the height of the bucket. However, do not raise the bucket so that the top of the load is higher than the horizontal line of sight from the operator. . 1. Gradual steering to left or right 2. Gradual steering to dilution 3. Direct line to dilution 2-128 WA430-6