Komatsu — Driving the Machine

OPERATION If Engine Stops If the engine stops on a slope: Apply the parking brake immediately. Lower the work equipment to the ground. Stop the machine. Put the directional lever in the neutral position. Start the engine again. Driving the Machine When the machine travels at high speed for a long distance, the tires become extremely hot. This causes early wear of the tires. Avoid traveling at high speed for a long distance. If the machine must be driven for a long distance, take the following precautions. Follow the regulations related to this machine and drive carefully. Before driving the machine, carry out the checks before starting; see “Check Before Starting Engine” on page 2-80.

The most suitable tire pressure, travel speed, or tire type differ according to the condition of the travel surface. Contact your Komatsu distributor or tire dealer for information. The following table is a guide to suitable tire inflation pressures and appropriate speeds when traveling on a paved surface with the standard tires (23.5-25-16PR(L3)). Tire pressure and speed Check the tire pressure before starting, when the tire is cool. After traveling for one hour, stop the machine for 30 minutes. Check the tires and other parts for any abnormality. Check the oil and coolant levels. Always travel with the bucket empty. Never put “calcium chloride” or “dry ballast” in the tires when traveling.

2-138 WA430-6 Front wheel 350 kPa (3.5 kg/cm2) [51 psi] Rear wheel 310 kPa (3.1 kg/cm2) [45 psi] Travel Speed 14 km/h (8.7 mph)