Komatsu — Driving Up or Down Slopes

Turning When Tires Are Stationary OPERATION Do not operate the steering when the machine is stationary. If the steering is operated when the machine is stationary, it will cause wear or cuts in the tires. In addition, it will reduce the durability of the frame and the undercarriage. Wheel Brake Does Not Work If the machine does not stop when you depress the brake pedal, use the parking brake to stop the machine. Remark If the parking brake has been used as an emergency brake, contact your Komatsu distributor to have the parking brake checked for any abnormality.

Permissible Water Depth When working in water or on swampy ground, do not let the water come above the bottom of the axle housing (1). After finishing the operation, wash and check the lubricating points. Lower the Center of Gravity when Turning When turning on slopes, lower the work equipment to lower the center of gravity before turning. It is dangerous to turn the machine suddenly on slopes. Driving Up or Down Slopes Braking on Downhill Slope If the foot brake is used frequently when traveling downhill, the brake will overheat and may be damaged.

To prevent this, place the gearshift lever at a low speed range and use the braking force of the engine to reduce the speed when traveling downhill. Normally, the most suitable speed range when traveling down a slope is the speed range needed when traveling up that slope. When braking, use the right brake pedal. If the correct speed range is not used, the torque converter oil may overheat. If this happens, shift down one gear to reduce the oil temperature.

If the torque converter oil temperature indicator does not return to the white range even when the gearshift is in 1st gear, stop the machine; place the directional selector lever at the N position; and run at the engine at a mid-range speed until the gauge enters the white range. Remark If there is danger of the engine over-running, the central warning lamp illuminates and the buzzer sounds intermittently. At the same time, the engine speed flashes on the meter display. Limit the engine speed and machine travel speed when operating. See “Brake Oil Pressure Caution Lamp” on page 2-16 for further information. WA430-6 2-137