OPERATION Loosened Boulders Do not use this machine to deal with loosened boulders. If the boulder is dropped by mistake when handling it, there is danger that it may fall on top of the operator's compartment and cause serious personal injury. Do not use this machine to handle hanging rocks. There is danger that the rock will fall while moving it and hit the machine or operator's cab. If dropped boulders hit the work equipment cylinders, there is danger that the cylinder will bend and be unable to move. If the boulder is dropped on the operator's compartment, there is danger of serious personal injury. Pit Excavation Do not try to shave off natural rock (roots) remaining from blasting.
Excessive force will be applied to the machine and there is danger that this may damage the work equipment or frame. For pit excavation operations, do not use a wheel loader. Use a bulldozer or hydraulic excavator. Cutting Face Operations Do not excavate cutting faces. If the cutting face is excavated, excessive force will be applied to the machine. There is danger that this may damage the bucket, work equipment, or frame. In particular, do not excavate with the bucket raised to a height above the travel posture. For excavation of cutting faces, use a hydraulic excavator.
Switching Between Forward and Reverse Do not switch the direction of travel of the machine between forward and reverse when traveling at high speed or when the accelerator pedal is depressed. When the machine is traveling at high speed or when the accelerator pedal is depressed, the engine speed is high. If the direction of travel is switched between forward and reverse, an excessive load is applied to the engine, torque converter, transmission, and other parts of the power train. This will reduce the service life of the machine. When switching between forward and reverse, travel at low speed; reduce the engine speed; then stop the machine and switch the direction of travel. 2-136 WA430-6