Bucket Dump Operation When Digging OPERATION Do not operate the bucket in the DUMP direction when digging. If the bucket control lever is operated to the DUMP position during digging, the machine will not be able to travel forward; the tires will slip; and an excessive load will be brought to bear on the work equipment. Carry out the scooping-up operations as follows. 1. When thrusting the bucket in, raise the lift arm slightly at the same time. Ample driving force will work on the front wheels. 2. To fill the bucket, operate the bucket tilt and lift two to three times repeatedly when thrusting the bucket in. Operate the control lever slowly near the end of the bucket tilt. 3.
When the bucket reaches the end of the tilt stroke, depress the brake pedal to stop the machine. When doing this, do not push the bottom of the bucket against the pile. If the bucket is pushed against the pile, the bucket, cylinders, and work equipment will be damaged. 4. When the scooping-up operation is completed, operate the bucket tilt and dump. Apply the brakes when traveling in reverse to stabilize the load inside the bucket and prevent spillage of the load. Remark To reduce the generation of heat by the torque converter, keep the target time for the digging operation within 10 seconds from the start of thrusting in to the completion of scooping up.
The fuel consumption increases during digging work. Fuel cost is saved by shortening the digging time. Front Wheels Going on Blasted Rock Do not carry out operations that make the front wheels ride up on blasted rock. If the front wheels go on top of blasted rock, there is danger that the sharp parts of the blasted rock will cut the tires. In particular, avoid pushing the bucket in too far. When operating near natural rock after blasting (roots), do not let the front wheels ride up on the natural rock (roots). For scooping-up operations near natural rock (roots), do not use a wheel loader. Use a bulldozer or hydraulic excavator. WA430-6 2-135