Komatsu — Adjusting Bucket Positioner

3. Loosen two bolts (1) and adjust plate (2) so that the bottom edge is in line with the center of the sensing surface of proximity switch (3). Then tighten the bolts to hold the plate in position. OPERATION 4. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 to 0.197 in) between plate (2) and the sensing surface of proximity switch (3). Then tighten the nuts to hold in position. Tightening torque: . . . . . . . . . . . . . . 17.2 ±2.5 N•m (152 ±22 lbf in) 5. After adjusting, start the engine and operate the lift arm control lever. Check that the lever is automatically returned to HOLD when the bucket reaches the desired height. Adjusting Bucket Positioner 1.

Lower the bucket to the ground; set it to the desired digging angle; and return the bucket control lever to the HOLD position (b). 2. Set the work equipment lock lever (1) to the LOCK position (L), then stop the engine. 3. Loosen two bolts (1); adjust the position of mounting bracket (4) of the proximity switch so that the rear tip of bar (2) is in line with the center of the sensing surface of proximity switch (3); then tighten bolts to hold the bracket in position. 4. Loosen two bolts (5); adjust so that the clearance between bar (2) and support (6) is 0.5 to 2 mm (0.020 to 0.079 in); then tighten bolts (5) to hold in position. 5.

Loosen two nuts (7); adjust so that the clearance between bar (2) and the sensing surface of proximity switch (3) is 3 to 5 mm (0.118 to 0.197 in); then tighten the nuts to hold in position. Tightening torque: . . . . . . . . . . . . . . 17.2 ±2.5 N•m (152 ±22 lbf in) 6. After adjusting, start the engine and raise the lift arm. Operate the bucket control lever to the DUMP position, then operate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging angle. WA430-6 2-141