OPERATION HANDLING TIRES Precautions When Handling Tires If a tire has reached any of the following service limits, there is danger that the tire may burst or cause an accident. To ensure safety, replace it with a new tire. Service limits for wear: When the remaining depth of the groove on construction equipment tires (at a point approximately 1/4 of the tread width) is 15% of the groove depth on a new tire. When the tire shows marked uneven wear, stepped wear, or other abnormal wear, or when the cord layer is exposed. Service limits for damage: When there is external damage extending to the cord or when the cord is broken. When the cord is cut or there is dragging.
When the tire is peeling (there is separation). When the bead is damaged. For tubeless tires, when there is air leakage or improper repair. 1. Side wall 2. Shoulder 3. Tread 4. Breaker or belt (cord layer) 5. Bead 6. Inner liner 7. Carcass Remark It is dangerous to jack up the machine without taking proper care. Contact your Komatsu distributor when replacing the tires. After replacing the tires, carry out the breaking-in operation for approximately 30 hours (the time displayed on the service meter) until the tires and rims are settled. Pay particular attention to the following points when operating the machine. Avoid heavy loads (heavy digging operations) and operations at high speed.
Immediately after starting the engine, avoid sudden starts, sudden acceleration, unnecessary sudden stops, and sudden changes in direction. 2-154 WA430-6