Komatsu — Tire Pressure

Tire Pressure OPERATION Measure the tire pressure before starting operations, when the tires are cool. If the tire inflation pressure is too low, there will be overload; if it is too high, it will cause tire cuts and shock burst. To prevent these problems, adjust the tire inflation pressure according to the “Air Pressure Chart” on page 2-156. Deflection ratio = H - h / H x 100 When checking the tire inflation pressure, check also for small scratches or peeling of the tire, for nails or pieces of metal which may cause punctures, and for any abnormal wear. Clearing fallen stones and rocks from the operating area and maintaining the surface will extend the tire life and give improved economy.

For operations on normal road surfaces, rock digging operations: . . . . . . . . . . . . . . . . . . . . . .High end of range in Air Pressure chart Stockpile operations (loading of sand and other loose materials) on soft ground: . . . . . . . . . . . . . . . . . . . . . .Average pressure in Air Pressure chart Operations on sand (operations not using much digging force): . . . . . . . . . . . . . . . . . . . . . . Low end of range in Air Pressure chart As a guideline that can be checked visibly, the deflection ratio of the front tire (deflection/free height) is as follows: When carrying normal load (lift arm horizontal):. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . .Approximately 15 to 25% When digging (rear wheels off ground): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Approximately 25 to 35% If the deflection of the tire is excessive, raise the inflation pressure within the limits given in the Air Pressure chart in order to get a suitable deflection. WA430-6 2-155