Komatsu — Transportation Procedure

TRANSPORTATION OPERATION When transporting the machine, observe all applicable laws and regulations and be careful to assure safety. Transportation Procedure As a general rule, always transport the machine on a trailer. When selecting a trailer and transporting the machine, choose the optimum transportation method in reference to the weight and dimensions shown in “SPECIFICATIONS” on page 4-2. Note that machine specifications (weight and dimensions) vary depending on the kind of tires and bucket. When loading or unloading the machine, run the engine at low speed; travel at low speed; and operate slowly. When loading or unloading the machine, stop the trailer on firm, level ground.

Keep well away from the road shoulder. Use ramps of ample width, length, thickness, and strength. Install them securely at an angle of less than 15°. When using an embankment, compact the fill soil thoroughly and make sure that the slope face does not collapse. Remove the mud stuck to the undercarriage to prevent the machine from slipping to the side on the ramps. Remove any water, snow, ice, grease, or oil from the ramps. Never change direction on the ramps. There is danger that the machine may tip over. If it is necessary to change direction, return to the ground surface or the trailer platform; correct the direction; and start again.

The position of the center of gravity of the machine will change suddenly at the connection of the ramp and trailer. At this point, there is danger of the machine losing its balance. Always drive slowly over the connection point. When the machine is transported on a trailer, there is danger of serious personal injury or death during transportation. Observe the following rules: Always check the machine dimensions carefully. Depending on the work equipment installed, the machine weight, transportation height, and overall length may differ.

Check beforehand that all bridges and other structures on the transportation route are strong enough to withstand the combined weight of the transporter and the machine being transported. When traveling on public roads, ask the local authorities for permission to transport the machine. The machine can be divided into parts for transportation. Contact your Komatsu distributor to have the work done. Be sure the loading equipment and transportation equipment are in good condition and rated for your load. When loading or unloading, always use ramps or a platform. Check the ramps and support surfaces for damage, weak spots, missing boards, or excess wear.

If these surfaces look unsafe, too weak, or unstable, do not load the machine. Be sure the ramp surface is clean and free of grease, oil, ice, and loose materials. On rainy or snowy days, the ramp may be slippery, use extreme caution. Be sure the area you use to load the machine is flat and dry. Remove dirt from the tires of the machine. WA430-6 2-157