Komatsu — Loading Machine

OPERATION Loading and Unloading Trailers Loading Machine 1. Load on firm, level ground. Keep away from the edge of roads and ditches. 2. Always use ramps of adequate strength. Be sure that the ramps are wide, long, and thick enough to provide a safe loading slope. Take suitable steps to prevent the ramps from moving out of position or coming off the trailer. 3. Apply the brakes on the trailer and insert blocks (1) under the tires to keep the trailer in position. 4. Set the distance (3) between the ramps (2) to match the distance between the left and right tires, and make the angle (4) of the ramps a maximum of 15°. 5.

If the ramps (2) sag appreciably under the weight of the machine, put a wooden block (5) under the ramps to support them. 6. Run the engine at low idling and drive the machine slowly at low speed. 7. Raise the bucket high enough to clear all surfaces. 8. Determine the direction of the ramp, then slowly load the machine. Load the machine correctly in the specified position on the trailer. 9. Never correct your steering on the ramps. If necessary, drive off the ramps; correct the direction; then enter the ramps again. 10. Position the machine squarely on the deck. 11. For machines equipped with a cab, always lock the door (1) after boarding the machine.

If this is not done, the door may suddenly open during transportation. 12. Once the machine has been loaded, secure the machine by following the instructions in “Securing the Machine” on page 2- 159. 2-158 WA430-6