Unloading the Machine OPERATION When unloading the machine, always use ramps or a platform. Be sure the unloading area is flat and dry. 1. Unload on firm, level ground. Maintain a safe distance from the edge of the road. 2. Apply the brakes on the trailer and insert blocks (1) under the tires to ensure that the trailer does not move. 3. Set the distance (3) between the ramps (2) to match the distance between the left and right tires, and make the angle (4) of the ramps a maximum of 15°. If the ramps (2) sag appreciably under the weight of the machine, put a wooden block (5) under the ramps to support them. Be sure that the two sides are at the same height. 4.
Remove the chains and wire ropes fastening the machine to the trailer. 5. Set the frame lock bar to the FREE position (F). 6. Start the engine. Warm up the engine completely. 7. Check that the work equipment control lever is at the HOLD position, then set the work equipment lock lever to the FREE position (F). 8. Depress the right brake pedal, then set the parking brake switch to the OFF position (B) to cancel the parking brake. 9. Determine the direction of the ramps, then drive the machine slowly down the ramps. WA430-6 2-161