Lifting Procedure OPERATION Lifting work can be carried out only for machines with hook mark labels (lifting points). Before starting the lifting operation, stop the machine on level ground. Use the following procedure to set the machine in the proper posture and use the lifting equipment when lifting the machine. 1. Start the engine; make sure that the machine is horizontal; then set the work equipment to the travel posture (A). For details, see “Moving the Machine (Directional, Speed), Stopping the Machine” on page 2-106. (A): . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 – 50 cm (16 – 20 in) 2.
Check that the work equipment control lever is at the HOLD position and then set the work equipment lock lever to the LOCK position (L). 3. Stop the engine; check that the area around the operator’s compartment is safe; then set the frame lock bar to the LOCK position (L) so that the front frame and rear frame do not articulate. 4. Use wire ropes and slings that match the weight of the machine. Wind the wire rope and fix it to the lifting points as shown in “Lifting Position” on page 2-162. Remark Use protectors, etc. so that the wire ropes do not break at sharp edges or narrow places. Use threaders and bars having sufficient width so that the slings and wire ropes do not touch the machine.
For machines equipped with a rear full fender, remove the rear full fender before carrying out the operation. 5. Lift the machine so that it floats about 100 mm – 200 mm (4 to 8 in) above the ground. 6. Make sure that the wire ropes are not slack and that the machine is level. 7. If the wire ropes are taut and the machine is level, continue to lift the machine slowly. WA430-6 2-163