Battery OPERATION The battery generates flammable gas. Do not bring fire or sparks near the battery. Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with a large amount of water and consult a doctor immediately. Battery electrolyte dissolves paint. If it gets on the bodywork, wash it off immediately with water. If the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source. There is danger that the battery may explode. Battery electrolyte is toxic. Do not let it flow into drainage ditches or spray it on the ground surface. When the ambient temperature drops, the battery capacity will drop also.
If the battery charge ratio is low, the battery electrolyte may freeze. Maintain the battery charge as close as possible to 100%. Insulate the battery against cold temperature so that the machine can be started easily the next morning. Remark Measure the specific gravity and calculate the rate of charge from the following conversion table. As the battery capacity drops drastically in low temperatures, cover the battery or remove it from the machine; keep it in a warm place; and install it again the next morning. If the electrolyte level is low, add distilled water in the morning before beginning work. Do not add water after the day’s work.
Diluted electrolyte in the battery may freeze during the night. Precautions After Completion of Work Mud and water on the undercarriage can freeze overnight and make machine movement difficult the following morning. Observe the following precautions. Remove all mud and water from the machine body. In particular, wipe the hydraulic cylinder rods clean to prevent damage to the seals caused if mud, dirt, and/or water on the rod surface gets inside the seal. Park the machine on hard, dry ground. If this is impossible, park the machine on wooden boards. The boards help protect the tires from freezing to the ground so the machine can be moved the next morning. Fill the fuel tank to capacity.
This minimizes moisture condensation in the tank when the temperature drops. Open the drain valve and drain any water collected in the fuel system to prevent it from freezing. After Cold Weather When the season changes and the weather becomes warmer, do the following procedure. Replace all oil and fuel with fuel and oil of the specified viscosity. For details, see “RECOMMENDED FUEL, COOLANT, AND LUBRICANTS” on page 3-12. WA430-6 2-165 Charging Rate (%) Electrolyte Temperature 20°C (68°F) 0°C (32°F) -10°C (14°F) -20°C (-4°F) 100 1.28 1.29 1.30 1.31 90 1.26 1.27 1.28 1.29 80 1.24 1.25 1.26 1.27 75 1.23 1.24 1.25 1.26