Komatsu — After Storage

OPERATION LONG-TERM STORAGE Before Storage When putting the machine in storage for a long period (more than one month), do the following procedure. Clean and wash all parts and then store the machine indoors. If the machine must be stored outdoors, select level ground and cover the machine with a sheet. Completely fill the fuel tank; this prevents moisture from collecting inside the tank. Lubricate and change the oil before storage. Apply a thin coat of grease to the exposed portion of the hydraulic cylinder piston rods. Disconnect the negative terminals of the battery. Cover the battery or remove it from the machine and store it separately. Lock each control lever with the lock lever.

To prevent rust, fill the cooling system with Komatsu genuine Supercoolant (AF-NAC) (density between 30% and 68%). During Storage If it is necessary to perform the rust-prevention operation while the machine is indoors, open doors and windows for ventilation since the engine will be running. Be sure to provide adequate ventilation in order to prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of oil coats the moving parts. At the same time, also charge the battery. Run the air conditioner for three to five minutes once a month to lubricate all parts of the air conditioner compressor.

Always run the engine at low idle when doing this. When operating the work equipment, wipe off all the grease from the hydraulic cylinder rods. Check the refrigerant level twice a year. After Storage Remark If the machine has been stored without carrying out the monthly rust-prevention operation, contact your Komatsu distributor before returning the machine to operation. Before returning the machine to operation after a long-term period of storage, do the following procedure. Wipe off the grease from the hydraulic cylinder rods. Add oil and grease at all lubrication points. When a machine is stored for a long period, moisture in the air mixes with the oil.

Check the oil before and after starting the engine. If there is water in the oil, change the oil. Check that there is no rust on the engine pulley and no abnormality in the alternator belt. If there is excessive rust on the belt contact surface of the pulley, remove it with a wire brush. If the alternator belt is loose, adjust the belt tension to ensure that there is no slipping. For details about adjusting the belt tension, see “Check Alternator Drive Belt Tension, Replace” on page 3-78. 2-166 WA430-6