Komatsu — Towing the Machine

OPERATION TROUBLESHOOTING When Machine Runs Out of Fuel Always watch the fuel level and be careful not to run out of fuel. When starting the engine after running out of fuel, check carefully that the area around the engine is safe before cranking the engine. When starting the engine after running out of fuel, fill with fuel and bleed the air from the fuel system before starting the engine. For details about the air bleeding procedure, see “Replace Fuel Main Filter Cartridge (Standard Specification)” on page 3-72. Towing the Machine Serious injury or death could result if there is any mistake in the selection of wire rope or method of towing a disabled machine.

Always be sure to check carefully that the capacity of the wire rope used for towing is ample for the weight of the towed machine. Never use a wire rope which has cut strands (A), reduced diameter (B), or kinks (C). There is danger that the rope may break during the towing operation. Always wear leather gloves when handling wire rope. Never tow a machine on a slope. During the towing operation, never stand between the towing machine and the machine being towed. Move the machine slowly and do not to apply any sudden load on the wire rope. If there is a failure in the brake line, the brakes cannot be used. Be extremely careful when towing.

Remark Towing is to be used only for moving the machine a short distance to a place where inspection and maintenance can be carried out. The machine must not be towed for long distances. For details of the permissible towing load for this machine, see “SPECIFICATIONS” on page 4-2. For details about towing a machine when it has broken down, contact your Komatsu distributor. This machine must not be towed except in emergencies. When towing the machine, take the following precautions. Before releasing the brakes, put blocks under the wheels to prevent the machine from moving. If the wheels are not blocked, the machine may move suddenly.

When towing a machine, tow it at a low speed of less than 2 km/h (1.2 mph) and for a distance of a few meters, to a place where repairs can be carried out. If the machine must be moved long distances, use a transporter. 2-176 WA430-6