Komatsu — When Engine Cannot Be Used

If it is impossible to operate the steering and brakes of the machine being towed, do not let anyone ride on the machine. OPERATION Keep the angle of the tow rope as small as possible. Keep the angle between the center lines of the two machines to within 30°. When using a chain or cable, be sure that it is strong enough for the expected load and it is properly secured to the drawbar pins or tow hooks (if equipped). When pulling with a chain or cable, take up the slack slowly to avoid jerking. A chain or cable which fails under load can whip and cause serious injury. Stand clear.

Do not pull or tow unless the operator’s compartment is guarded against or out of reach of a whipping chain or cable. Failure to follow these instructions could cause serious injury. The towing machine should normally be of the same class as the machine being towed. Check that the towing machine and the towed machine both have ample braking power and that the towing machine has ample rimpull to control both machines on a slope or on the tow road. When towing a machine downhill, it may be necessary to connect another machine to the rear of the machine being towed in order to provide ample rimpull and braking power. This makes it is possible to prevent the machine from losing control.

Towing may be carried out under different conditions; it is impossible to determine beforehand the requirements for towing. Towing on flat horizontal roads requires the minimum rimpull; towing on slopes or on uneven road surfaces requires the maximum rimpull. Connect a wire rope to the part indicated by the arrow in the graphic. When Engine Can Be Used If the transmission and steering wheel can be operated and the engine is running, it is possible to tow the machine out of mud or to move it for a short distance to the edge of the road. The operator should sit in the cab of the machine being towed and operate the steering in the direction that the machine is towed.

When Engine Cannot Be Used When towing a machine with the engine stopped, use the following procedure. 1. The transmission oil does not lubricate the system; remove the front and rear drive shafts. If necessary, block the tires to prevent the machine from moving. 2. The steering cannot be operated; remove the steering cylinder. Even if the brakes are in good condition, the brakes can only be used a limited number of times. There is no change in the operating force for the brake pedal but the braking force is reduced each time the pedal is depressed. 3. Connect the towing equipment securely.

When carrying out towing operations, use two machines of at least the same class as the machine being towed. Connect one machine to the front and one to the rear of the machine being towed; remove the blocks from the tires; and tow the machine. 4. The parking brake cannot be turned OFF. Release the parking brake; see “Releasing Parking Brake” on page 2-178. WA430-6 2-177